YASKAWA FSDrive-MV1S - User Constant Tables Overview

User Constant Tables
5-3
User Constant Tables
This section describes the contents of the user constant tables.
Refer to the parameter setting table included in the performance test record for the set point at the time of
shipment and the completion of a test run.
The name of the input-and-output terminal in the User constant tables corresponds as follows with the
name of the control circuit terminal.
Group
Number
Group Name
Functional
Number
Functional Name
A Setup Settings
A1 Initialize Mode
A3 Hi Speed Trace
A4 Lo Speed Trace
b Application Constants
b1 Operation Mode Selections
b2 DC Injection Braking
b3 Speed Search
C Autotuning Constants
C1 Acceleration/Deceleration
C2 S-curve Acceleration/Deceleration
C3 Motor Slip Compensation
C4 Torque Compensation
C5 Speed Control (ASR)
d Reference Constants
d1 Preset Reference
d2 Reference Limits
d3 Jump Frequencies
d5 Torque Control
E Motor Constant Constants
E1 V/f Pattern
E2 Motor Setup
F PLC Constants F8 PLC
H Terminal Function Constants
H1 Multi-function Contact Inputs
H2 Multi-function Contact Outputs
H3 Analog Inputs
H4 Multi-function Analog Outputs
H7 PG Setup
L Protection Function Constants
L1 Motor Overload
L2 Power Loss Ridethrough
L3 Stall Prevention
L4 Reference Detection
L6 Torque Detection
L7 Torque Limits
L8 Hardware Protection 1
L9 Hardware Protection 2
N Special Adjustments N2 Speed Feedback Detection Control Functions
o Digital Operator Constants
o1 Monitor Select
o2 Multi-function Selections
Y Factory Settings Y1 Factory Settings 2
T Motor Autotuning T1 Autotuning
U Monitor Constants
U1 Status Monitor Constants
U2 Fault Trace
U4 Calender
Constant Tables Control Circuit Terminal
Digital Input S1 to S20 DI_0 to DI_19
Digital Output DO1 to DO8 DO_0 to DO_7
Analog Input AI1 to AI4 AI_0 to AI_3
Analog Output AO1 to AO3 AO_0 to AO_3