YASKAWA FSDrive-MV1S - Page 54

Modes
3-11
Fig 3.6 Operation in Autotuning Mode
MENU
Operation
INV * MODE sel *
-DRIVE-
Monitor Display
Mode Selection Display
Quick Setting
INV * MODE sel *
-QUICK-
Programming
INV * MODE sel *
-ADV-
Tuning Mode
INV * MODE sel *
-A TUNE-
Setting Display
MENU
MENU
MENU
ESC
DATA
ENTER
The display will automatically
change depending on the
status of autotuning
Fault History
INV * MODE sel *
MENU
ESC
DATA
ENTER
ESC
DAT
A
ENTER
ESC
DAT
A
ENTER
Motor Setup(REV)
“0”
-A TUNE-
Tuning Mode Sel
(0.00 to 400.00)
“60.00Hz”
-A TUNE-
Rated Frequency
(0.00 to 400.00)
“60.00Hz”
-A TUNE-
Rated Frequency
6
“6”
-A TUNE-
Number of Poles
6
“6”
-A TUNE-
Number of Poles
Motor Setup(REV)
“0”
-A TUNE-
Tuning Mode Sel
Tuning Ready?
Press RUN key
CAL10
-A TUNE-
Auto Tuning
START >> GOAL
STOP key Aborted
48.0Hz/10.5A
-A TUNE- Rdy
Auto Tuning
STOP key
ER-10
-A TUNE-
Auto Tuning
STOP
RUN
START >>>>> GOAL
STOP key Aborted
48.0Hz/10.5A
-A TUNE- Rdy
Auto Tuning
Tune Successful
T-END
-A TUNE-
Auto Tuning
T1- 01 =0 *0*
T1- 05 =60.00Hz
T1- 06 =6 *6*
T1-06= 6 *6*
T1-05= 0 60.00Hz
T1-01= 0 *0*