YASKAWA iQpump Micro

YASKAWA TOEP YAIQPM 01A iQpump Micro Quick Start Procedure
iQpump Micro
Quick Start Procedure
Page 20
of 31
7.1 Confi gure the iQpump Micro for a dedicated pump application. DO NOT RUN
THE MOTOR. Ensure all protective covers are installed and power is turned on.
Available iQpump Micro Application Macro Settings using parameter A1-03 :
• 6008 Constant Pressure Mode (PSI) [Factory Default] Note: Do not change unless pump application differs from default.
• 6009 Pump Down Level Mode (Ft)
• 7770 General Purpose Mode
• 7771 Submersible Motor GP Mode
7.2 Select Application Macro Parameter A1-03
LED Digital Operator (Standard)
Press two times until the digital operator shows the parameter menu.
2X
Inc./Dec. Selection
Select Application
Switch to Edit Mode
Press to select.
2X
5 00.0
PAr A1-01
A1-03 0000 6008
Enter Application Parameters (Standard)
Hold button for 3 sec. to go back to the main menu.
3X
Select Parameter.
Switch to Edit Mode Save New ValueModify Value
5 00.0 5tuP
E2-01
1.90
2.90 E2-01
Go Back to Main Menu (Standard)
Hold button for 3 sec. to go back to the main menu.

Application Specifi c Setup
7
STEP