YASKAWA iQpump Micro

YASKAWA TOEP YAIQPM 01A iQpump Micro Quick Start Procedure
iQpump Micro
Quick Start Procedure
Page 28
of 31
13.1 HAND Mode
The iQpump Micro is operated in HAND mode by performing the following tasks:
• Program all parameters
• Verify motor rotation direction
LED Digital Operator (Standard)
PRESS TO TURN OFF
PRESS HAND MODE
0 to 10 Vdc Connection
P1
E(G)
0 ~ 10 Vdc
P2 PC A1 A2 +V AC AM AC MP
Cable
Shield
P1
Press to access HAND Speed. Use to change HAND Speed value.
Press to save value.
Set parameter P5-01 ‘HAND Mode Ref.’ to ‘0’ to adjust the hand mode reference
from an external 0 – 10V signal connected to terminals TB1-1, A1 and AC.
Hand Speed Reference from Analog Input (0 to 10 Vdc)
F40.00 040.00

Hand Mode Operation
13
STEP