YASKAWA iQpump Micro

YASKAWA TOEP YAIQPM 01A iQpump Micro Quick Start Procedure
iQpump Micro
Quick Start Procedure
Page 19
of 31
6.1 Access the Parameter Menu and Change Parameter Values. DO NOT RUN THE
MOTOR. Ensure all protective covers are installed and power is turned on.
LED Digital Operator (Standard)
Press
two times until
.
the digital operator shows the parameter
menu (PAr) then press
iQpump Micro digital operator
power-up state
Press to select the digit
you would like to change. Next use
and to select the
parameter group, sub-group or number.
Modify the parameter value using
and and press
to save the new value.
Select Parameter
Select Parameter Menu
5 0.00
paR
C1-01
0010.0
Monitor Motor Frequency and Current (Standard)
Press until the FOUT
LED turns on. The display now shows
the actual drive output frequency in Hz.
Pressing again will
show the motor output current. The ‘A’
behind the value means ‘Amps’.
iQpump Micro digital operator
power-up state
Motor Current
Output Frequency
5 00.0
42.78
0.8a
Refer to the iQpump Micro User Manual, (Document No. TOEPYAIQPM03) to access additional drive monitors

Adjust and Monitor iQpump Micro Settings
6
STEP