YASKAWA JEPMC-CP3202-E - Page 111

3.2 Function Modules
The M-EXECUTOR
3-61
3
CPU Unit Functionality
The following table describes the M-EXECUTOR items that are displayed on the Module Configuration
Definition Tab Page.
No. Item Display/Setting Item Editing

Function Module/Slave
Displays whether the M-EXECUTOR is enabled.
• UNDEFINED: Disabled
• M-EXECUTOR: Enabled
Possible

Status Displays the status of the M-EXECUTOR. Possible

Circuit No./Axis
Address
Start
Not used.
“----” is always displayed.
Not possible
Occupied
circuits

Motion Register
Not used.
“----” is always displayed.
Not possible

Register (Input/
Output)
Disabled
Not used.
“----” is always displayed.
Not possible

Start- End
Displays the range of registers that is used as the I/O
area.
• Setting range: 00000 to 07FFF hex or 10000 to
17FFF hex
Refer to the following section for details.
 Details on the I/O Registers (page 3-62)
Possible

Size
The size of the I/O area is displayed in words.
• Setting range: 64 to 128
Four words each of input registers and output registers
are required to register a single motion program or
sequence program in the M-EXECUTOR. If you need
to register more than 16 programs, set the size with
four additional words for each program to add. A max-
imum of 32 programs can be registered (maximum
number of program definitions).
Possible

Scan
Not used.
“----” is always displayed.
Not possible

Comment
Display the user comment.
Enter a comment of up to 16 characters.
Possible