YASKAWA JEPMC-CP3202-E

1.3 Devices and Components That Are Required to Build a System
MP3200 Unit List
1-11
1
Introduction
* You cannot use an MP2000-series EXIOIF Module Cable (model: JEPMC-W2091-()).
MP3200 Unit List
The following table lists the MP3200 Units.
* Refer to the following section for details.
3.2 Function Modules - Motion Control Function Modules (SVC32 and SVR32) (page 3-50)
−
Panel-mounting
Bracket
Used to mount the
MP3200 inside a control
panel.
JEPMC-OP3001-E
This Attachment is provided with the Power
Supply Unit.
−
Rack Reinforcement
Bracket
Used to mount the Sub
CPU Unit to the Main
Rack with screws.
JEPMC-OP3006-E
Refer to the following manual for informa-
tion on model selection and mounting meth-
ods.
MP2200/MP3000 Series Machine Controller
System Setup Manual (Manual No.: SIEP
C880725 00)
JEPMC-OP3007-E
Continued from previous page.
No. Name Use Model Remarks
Observe all precautions when combining MP3200 Units. Refer to the following section for details.
Precautions When Combining MP3200 Units (page 1-14)
Unit
Abbrevia-
tion
Model Description
Maximum
Internal
Current
Consumption
Power Supply Units
PSA-12 JEPMC-PSA3012-E AC power supply −
PSD-12 JEPMC-PSD3012-E DC power supply −
CPU Unit
CPU-201 JEPMC-CP3201-E − 2,000 mA
CPU-202 JEPMC-CP3202-E − 4,000 mA
Motion Control
Function Module
SVC32 − MECHATROLINK -III −
SVR32 − Virtual axes* −
Communications
Function Module
218IFD − Ethernet −
Base Units
MBU-B03 JEPMC-BUB3003-E 3 slots 10 mA
MBU-B05 JEPMC-BUB3005-E 5 slots 10 mA
MBU-B08 JEPMC-BUB3008-E 8 slots 10 mA
Rack Expansion Interface
Unit
EXU-001 JEPMC-EXU3001-E For Main Rack 1,500 mA
EXU-002 JEPMC-EXU3002-E For Expansion Rack 1,500 mA
Note