4 Teaching
4.6 User Variables
4-49
HW1485509
HW1485509
4.6.3.2 Setting Position Variable Using the Numeric Keypad
1. Select {Position} under {Variables}.
2. Select desired position variable type (ex. P000).
– The data of the desired variable is shown below.
3. Select the {Reference Type}.
– The selection panel on Reference Type will appear.
If the position variable has already been set, a confirmation pop-up
window will appear. Select {PROCEED} to clear the data.
4. Select the reference type.
5. Tap the cursor to the desired data to be input.
6. Input the value for the position.
7. Press {ENTER}.
– The value is set in the cursor position.
8. Tap {Save} to save the position variable.
9. Insert the variable name as an option.
To Next Page
Loading...