7 Concurrent I/O (Input/Output)
7.8 I/O Allocation and EtherNet/IP Configuration
7-48
HW1485509
HW1485509
7.8.5 Modifying Allocations using Input/Output Table
After a device has been added, its allocation (i.e. “Starting Group #”) can
be modified from the Input/Output Table by the following steps:
1. From the Input/Output table, press the {Select Inputs} or {Select
Outputs} button.
– This will enter a special “Selection Mode”, and the bottom detail
panel will be disabled.
Fig. 7-41: Input Table Selection Mode
To Next Page
Loading...