9-15
155976-1CD
HW0485249
ES165D
9 Maintenance and Inspection
9.3 Notes on Grease Replenishment/Exchange Procedures
3. Inject the grease through the grease inlet using a grease gun
– Grease type: Molywhite RE No. 00
–
Amount of grease: 300 cc
(600 cc for 1st supply)
– Air supply pressure of grease pump: 0.3 MPa or less
– Grease injection rate: 8 g/s or less
4. Move the R-, B-, T-Axes for a few minutes to discharge excess grease.
5. Wipe the discharged grease with a cloth, and reinstall the plug. Before
inst
alling the plug, apply Three Bond 1206C on the thread part of the
plug, then tighten the plug with a tightening torque of 5 N•m
(0.51 kgf•m).
6. Remove the grease zerk from the grease inlet, and reinstall the plug.
Before inst
alling the plug, apply Three Bond 1206C on the thread part
of the plug, then tighten the plug with a tightening torque of 5 N•m
(0.51 kgf•m).
9.3.4.2 Grease Replenishment for R-Axis
Speed Reducer
(Refer to Fig. 9-7 “U-Arm Diagram”.)
1. Remove the hexagon socket head plug PT1/8 from the grease
exhaust port.
2. Install a grease zerk A-PT1/8 to the grease inlet. (The grease zerk is
d
elivered with the manipulator.)
3. Inject the grease through the grease inlet using a grease gun
– Grease type: Molywhite RE No. 00
–
Amount of grease: 240 cc
(480 cc for 1st supply)
– Air supply pressure of grease pump: 0.3 MPa or less
– Grease injection rate: 8 g/s or less
4. Move the R-Axis for a few minutes to discharge excess grease.
5. Wipe the discharged grease with a cloth, and reinstall the plug. Before
inst
alling the plug, apply Three Bond 1206C on the thread part of the
plug, then tighten the plug with a tightening torque of 5 N•m
(0.51 kgf•m).
6. Remove the grease zerk from the grease inlet, and reinstall the plug.
Before inst
alling the plug, apply Three Bond 1206C on the thread part
of the screw, then tighten the plug with a tightening torque of 5 N•m
(0.51 kgf•m).
If grease is injected with the plug on, the grease will leak
inside the motor and may cause a damage. Make sure to
remove the plug before the grease injection.
To Next Page
Loading...
