YASKAWA MOTOMAN-MH215 II - Grease Replenishment for Balancer Connection Part

9-23
177010-1CD
HW1483759
9 Maintenance and Inspection
9.3 Grease Replenishment/Exchange
MH215
II
9.3.1.5 Grease Replenishment for Balancer Connection Part
Fig. 9-8: Balancer Connection Part
1. Remove the hexagon socket head plugs of connection and .
(Refer to Fig. 9-8 “Balancer Connection Part”.)
– Grease type: Alvania EP grease 2
– Amount of grease: 5 cc
(10 cc for 1st supply)
2. Inject grease through grease inlets of connection and using a
grease gun.
3. Reinstall the plugs PT1/8 of connection and . Before installing
the plug, apply Three Bond 1206C on the thread part of the plug, then
tighten the plug with a tightening torque of 4.9 N•m (0.5 kgf•m).
Hexagon socket head plug PT1/8
Hexagon socket head plug PT1/8
Exhaust port 1
Exhaust port 2
Hexagon socket head plug PT1/8
Connection 1 Tapered roller bearing
(2 bearings)
Grease zerk A-PT1/8 (2 grease zerks)
Connection 1 Grease inlet
Connection 2 Needle bearing
Connection 2 Grease inlet
NOTE
The exhaust port is used only for air flow.
Do not inject excessive grease through the gear grease
inlet.
81 of 102