2.4 Selecting Cables
2-15
• Use the table below to select shielded pre-wired cables for your SGMSH Sigma II
servomotor. These are suitable for IP67 environments.
* The “(A)” at the end of the cable number indicates the revision level. The revision level
may be subject to change prior to this catalog’s reprinting.
• Use the table below to select mating connectors for your SGMSH Sigma II series
servomotor.
* Connectors are manufactured by DDK and listed here with the largest standard cable
clamp available.
** Choose the connector and the associated cable clamp for a complete assembly. The
connectors listed in the table are suitable for IP67 environments.
Cable Description (C)
Motor
Size
(kW)
Part Number*
Comments
Item
Class
without Brake with Brake
Power Cable with
Connectors
(IP67)
1.0,
1.5, 2.0
B1CE-
(A)
B1BCE-
(A)
Use the following key to
specify required cable
length (last digit of part
number):
03. 3m
05: 5m
10: 10m (standard)
15: 15m
20: 20m
Limited
Stock
3.0
B2CE-
(A)
B3BCE-
(A)
4.0
5.0
B3CE-
(A)
Connector Description (D)
Motor
Size (kW)
Part Number*
Comments
Item
Class
without Brake with Brake
Connector for
Motor Power
Cable**
1.0, 1.5,
2.0
CE05-8A18-10SD-B-BAS
CE3057-10A-1(D265)
CE05-8A20-15SD-B-BAS
CE3057-12A-1(D265)
L-type
connector
Cable clamp
Limited
Stock
3.0, 4.0,
5.0
CE05-8A22-22SD-B-BAS
CE3057-12A-1(D265)
CE05-8A24-10SD-B-BAS
CE3057-16A-1(D265)
L-type
connector
Cable clamp
Connector for
Encoder Cable
(incremental or
absolute
encoder)
All
CE02-6A20-29NSW
and
CE20BA-S
CE3057-12A-3(D265)
L-type connector
(plug and back
shell)
Cable clamp
(for diameters
0.265 to 0.394in)
To Next Page
Loading...
