User Constants
10-25
10
* 3. The factory setting is 1.0 when using flux vector control.
* 4. The factory setting is 2.00 s when Inverter capacity is 55 kW min.
The factory setting will change when the control method is changed. The open-loop vector factory setting is given.
* 5. The factory settings depend on the Inverter capacity. The values for a 200 V Class Inverter of 0.4 kW are given.
* 6. When the control method is changed, the factory settings will change. The flux vector factory settings are given.
* 7. These are values for a 200 V Class Inverter. Values for a 400 V Class Inverter are double.
* 8. The factory settings in the parentheses are for 3-wire sequence.
* 9. E1-11 and E1-12 are disregarded when set to 0.0.
* 10.E1-13 is set to the same value as E1-05 by autotuning.
* 11.The same capacity as that of the Inverter will be set if the constants are initialized.
* 12.If the setting is 0, the axis will accelerate to the specified speed for the specified acceleration time (C1-01 to C1-08).
* 13.Applicable for G7-Series Inverters with software version PRG: 1033 and later.
* 14.This constant can be monitored or set only when F is set for C6-02.
* 15.By setting E2-11 (Motor rated output) the appropriate value will be set.
To Next Page
Loading...
