YASKAWA Varispeed CIMR-G7A - Page 457

Index-3
Index
overtorque 2, 7-12
overtorque detected 1, 7-4
overtorque detected 2, 7-4
P
password, 4-16, 6-151
periodic inspection, 8-2
periodic maintenance of parts, 8-3
PG (encoder) pulses, 2-39
PG disconnection, 7-12
PG disconnection detected, 7-5
PG pulse monitor output dividing ratio, 6-156
PG rotation direction, 6-155
PG speed control card, 6-155
PG speed control cards, 2-31
PGO PG Open, 7-12
PID control, 6-102
PID control selection error, 7-15
PID feedback reference lost, 7-6, 7-13
power ON, 4-3
Q
quick programming mode, 3-4, 3-7
R
radio interference, 2-20
rated current, 6-56
RJOG, 6-81
run command, 6-8
S
S-curve characteristics, 6-19
slip compensation function, 6-34
speed control with PG, 6-153
stabilizing speed, 6-39
stall prevention function, 6-21, 6-23, 6-48
standard connection diagrams, 2-15
standard inverter specifications, 9-2
stopping methods, 6-10
straight solderless terminals, 2-23, 2-38
surge absorber, 2-17
switching motors when the power supply is ON, 6-144
T
terminal block, 2-5
thermal overload relay, 2-19
tightening torque, 2-38
timer function, 6-101
torque compensation, 6-36
torque limit function, 6-44
trial operation, 4-1
troubleshooting, 7-1, 7-19
U
UL3 Undertorq Det 1, 7-12
UL4 Undertorq Det 2, 7-12
undertorque 1, 7-12
undertorque 2, 7-12
undertorque detected 1, 7-5
undertorque detected 2, 7-5
user constant access levels, 4-16
UV DC Bus Undervolt, 7-11
V
V/f control, 4-8
V/f control with PG, 4-8
V/f pattern, 6-116, 6-117
verify mode, 3-4, 3-12
VS operator, 10-15
W
watchdog timer fault, 7-8
wire size, 2-22
wiring, 2-1