Yealink CP860 - Basic Network Settings

YealinkCP860 Phones Configuring Guide
22
the phone to obtain the time and date from the Simple Network Time Protocol (SNTP) server
automatically, or configure the date and time manually. If the phone cannot obtain the time and
date from the SNTP server, contact your system administrator for more information.
To configure the NTP server, time zone and DST via CommPortal phone configurator:
1. Click on Preferences->Time&Date.
2. Select NTP from the pull-down list of Obtain Time Method.
3. Select the desired time zone that applies to your area from the pull-down list of Time
Zone.
The default time zone is "Match My Account". This means the phone will support DST &
timezone sync settings with the Metaswitch EAS/CFS account.
4. Enter the domain names or IP addresses in the Primary NTP Server and Secondary NTP
Server fields respectively.
5. Enter the desired interval to update time and date from the NTP server in the NTP Query
Interval field.
6. Select the desired value from the pull-down list of Daylight Saving.
If you select Enabled, do one of the following:
a) Select DST By Date from the Fixed Type field.
1) Enter the start time in the Start Date field.
2) Enter the end time in the End Date field.
Value format is: Month/Day/Hour.
The mapping is:
 For month: 1=Jan, 2=Feb,…, 12=Dec;
 For day: 1=the first day in a month,…, 31= the last day in a month;
 For hour: 0=0am, 1=1am,…, 23=11pm.
b) Select DST By Week from the Fixed Type field.