Yealink SIP-T21 E2

Administrator’s Guide for SIP-T2 Series/T19(P) E2/T4 Series/T5 Series/CP860/CP920 IP Phones
124
Parameters
Permitted Values
Default
Configures the EAP In-Band provisioning method for EAP-FAST.
0-Unauthenticated Provisioning
1-Authenticated Provisioning
If it is set to 0 (Unauthenticated Provisioning), EAP In-Band provisioning is enabled by
server unauthenticated PAC (Protected Access Credential) provisioning using anonymous
Diffie-Hellman key exchange.
If it is set to 1 (Authenticated Provisioning), EAP In-Band provisioning is enabled by server
authenticated PAC provisioning using certificate based server authentication.
Note: It works only if the value of the parameter “static.network.802_1x.mode” is set to 7
(EAP-FAST). If you change this parameter, the IP phone will reboot to make the change
take effect.
Web User Interface:
Network->Advanced->802.1x->Provisioning Mode
Phone User Interface:
None
static.network.802_1x.anonymous_identity
String within 512
characters
Blank
Description:
Configures the anonymous identity (user name) for 802.1X authentication.
It is used for constructing a secure tunnel for 802.1X authentication.
Example:
static.network.802_1x.anonymous_identity = anonymous
Note: It works only if the value of the parameter “static.network.802_1x.mode” is set to 2,
3, 4, 5, 6 or 7. If you change this parameter, the IP phone will reboot to make the change
take effect.
Web User Interface:
Network->Advanced->802.1x->Anonymous Identity
Phone User Interface:
None
static.network.802_1x.identity
String within 32
characters
Blank
Description:
Configures the identity (or user name) for 802.1x authentication.
Example: