Yealink SIP-T2XP - Page 172

Administrator’s Guide for SIP-T2xP and SIP-T19P IP Phones
156
Memory key LED (configured as a BLF key and BLF LED Mode is set to 2)
LED Status
Description
Fast flashing red (200ms)
The monitored user receives an incoming call.
Solid red
The monitored user is dialing.
The monitored user is talking.
Slow flashing red (1s)
The call is parked against the monitored user’s
phone number.
The monitored user’s conversation is placed on
hold.
Off
The monitored user is idle.
The monitored user does not exist.
Line key LED (configured as a BLF key and BLF LED Mode is set to 3)
LED Status
Description
Fast flashing green (200ms)
The monitored user receives an incoming call.
Solid green
The monitored user is dialing.
The monitored user is talking.
The monitored user’s conversation is placed on
hold.
Slow flashing green (1s)
The call is parked against the monitored user’s
phone number.
Off
The monitored user is idle.
The monitored user does not exist.
Memory key LED (configured as a BLF key and BLF LED Mode is set to 3)
LED Status
Description
Fast flashing red (200ms)
The monitored user receives an incoming call.
Solid red
The monitored user is dialing.
The monitored user is talking.
The monitored user’s conversation is placed on
hold.
Slow flashing red (1s)
The call is parked against the monitored user’s
phone number.
Off
The monitored user is idle.
The monitored user does not exist.
Note
BLF LED Mode feature is only applicable to IP phones running firmware version 72 or
later.