Yealink SIP-T2XP - Page 294

Administrator’s Guide for SIP-T2xP and SIP-T19P IP Phones
278
Example
network.pc_port.mask = 255.255.255.0
Parameter-
network.pc_port.dhcp_server
Configuration File
<y0000000000xx>.cfg
Description
Enables or disables the DHCP service for the
PC attached to the PC port when the PC port is
configured as Router.
Note: If you change this parameter, the IP
phone will reboot to make the change take
effect. It is not applicable to SIP-T19P and
SIP-T21P IP phones.
Format
Boolean
Default Value
1
Range
Valid values are:
0-Disabled
1-Enabled
Example
network.pc_port.dhcp_server = 1
Parameter-
network.dhcp.start_ip
Configuration File
<y0000000000xx>.cfg
Description
Configures the start IP address that the IP
phone assigns for the PC attached to the PC
port when the PC port is configured as Router.
Note: If you change this parameter, the IP
phone will reboot to make the change take
effect. It is not applicable to SIP-T19P and
SIP-T21P IP phones.
Format
IP Address
Default Value
10.0.0.10
Range
Not Applicable
Example
network.dhcp.start_ip = 10.0.0.10
Parameter-
network.dhcp.end_ip
Configuration File
<y0000000000xx>.cfg
Description
Configures the end IP address that the IP
phone assigns for the PC attached to the PC