Yealink SIP-T2XP - Page 295

Appendix
279
port when the PC port is configured as Router.
Note: If you change this parameter, the IP
phone will reboot to make the change take
effect. It is not applicable to SIP-T19P and
SIP-T21P IP phones.
Format
IP Address
Default Value
10.0.0.100
Range
Not Applicable
Example
network.dhcp.end_ip = 10.0.0.100
Parameter-
firmware.url
Configuration File
<y0000000000xx>.cfg
Description
Configures the access URL of firmware.
Note: If you change this parameter, the IP
phone will reboot to make the change take
effect.
Format
URL
Default Value
Blank
Range
String within 511 characters
Example
firmware.url =
http://192.168.1.20/2.72.0.1.rom
Parameter-
auto_provision.power_on
Configuration File
<y0000000000xx>.cfg
Description
Enables or disables the IP phone to perform
an auto provisioning process when powered
on.
Format
Boolean
Default Value
1
Range
Valid values are:
0-Disabled
1-Enabled
Example
auto_provision.power_on = 1