Yealink SIP-T2XP - Page 300

Administrator’s Guide for SIP-T2xP and SIP-T19P IP Phones
284
Format
Boolean
Default Value
1
Range
Valid values are:
0-Disabled (power indicator LED does not
flash)
1-Enabled (power indicator LED fast flashes
(300ms) green)
Example
phone_setting.mute_power_led_flash_enabl
e = 1
Parameter-
phone_setting.hold_and_held_p
ower_led_flash_enable
Configuration File
<y0000000000xx>.cfg
Description
Enables or disables the power indicator LED
to flash when a call is placed on hold or is
held.
If it is set to 0, the status of the power
indicator LED is determined by the value of
the parameter
“phone_setting.common_power_led_enable”
.
Format
Boolean
Default Value
0
Range
Valid values are:
0-Disabled (power indicator LED does not
flash)
1-Enabled (power indicator LED fast flashes
(500ms) green)
Example
phone_setting.hold_and_held_power_led_fla
sh_enable = 0
Parameter-
phone_setting.talk_and_dial_po
wer_led_enable
Configuration File
<y0000000000xx>.cfg
Description
Enables or disables the power indicator LED
to be turned on when the phone is busy.
If it is set to 0, the status of the power
indicator LED is determined by the value of