Yealink SIP-T2XP - Page 382

Administrator’s Guide for SIP-T2xP and SIP-T19P IP Phones
366
Parameter-
multicast.receive_priority.enable
Configuration File
<y0000000000xx>.cfg
Description
Enables or disables the IP phone to handle
the incoming multicast paging calls when
there is an active multicast paging call on
the IP phone.
If it is set to 1 (Enabled), the IP phone will
answer the incoming multicast paging call
with a higher priority and ignore that with a
lower priority.
Format
Boolean
Default Value
1
Range
Valid values are:
0-Disabled
1-Enabled
Example
multicast.receive_priority.enable =1
Parameter-
multicast.receive_priority.priority
Configuration File
< y0000000000xx >.cfg
Description
Configures the priority of multicast paging
calls.
1 is the highest priority, 10 is the lowest
priority.
If it is set to 0, all incoming multicast paging
calls will be automatically ignored.
Format
Integer
Default Value
10
Range
0 to10
Example
multicast.receive_priority.priority = 10
Parameter-
multicast.listen_address.X.label
Configuration File
< y0000000000xx >.cfg
Description
Configures the label to be displayed on the
LCD screen when receiving the RTP