Yealink SIP-T2XP Administrator's Guide

Administrator’s Guide for SIP-T2xP and SIP-T19P IP Phones
26
Procedure
Network parameters can be configured manually using the configuration files or
locally.
Configuration File
<y0000000000xx>.cfg
Configure network parameters of
the IP phone manually.
For more information, refer to
Static Network Settings on page
271.
Local
Web User Interface
Configure network parameters of
the IP phone manually.
Navigate to:
http://<phoneIPAddress>/servlet
?p=network&q=load
Phone User Interface
Configure network parameters of
the IP phone manually.
To configure the IP address mode via web user interface:
1. Click on Network->Basic.
2. Select desired value from the pull-down list of Mode (IPv4/IPv6).
3. Click Confirm to accept the change.
A dialog box pops up to prompt that settings will take effect after a reboot.
4. Click OK to reboot the IP phone.
To configure a static IPv4 address via web user interface:
1. Click on Network->Basic.
2. In the IPv4 Config block, mark the Static IP Address radio box.

Yealink SIP-T2XP Specifications

General

Brand	Yealink
Model	SIP-T2XP
Category	IP Phone
Language	English