EasyManua.ls Logo

Yealink SIP-T40G

Yealink SIP-T40G
572 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
30
In DHCP environment:
Menu > Advanced (default password: admin) > Network > WAN Port > IPv6 > DHCP > Static DNS
(Enabled) > Primary DNS
Black-and-white Screen Phones:
Menu > Settings > Advanced Settings (default password: admin) > Network > WAN Port > IPv6 >
Static IPv6 Client > Pri.DNS
In DHCP environment:
Menu > Settings > Advanced Settings (default password: admin) > Network > WAN Port > IPv6 >
DHCP IPv6 Client > Static DNS(Enabled) > Pri.DNS
Parameter
static.network.ipv6_secondary_dns
[1]
<y0000000000xx>.cfg
Description
It configures the secondary IPv6 DNS server for the wired network.
Note: It works only if “static.network.ip_address_mode" is set to 1 (IPv6) or 2 (IPv4 & IPv6). In DHCP
environment, you also need to make sure “static.network.ipv6_static_dns_enable" is set to 1 (On).
Permitted
Values
IPv6 Address
Default
Blank
Web UI
T57W/T54W/T53W/T53/T48U/T46U/T43U/T42U:
Network > Basic > IPv6 Config > Static IPv6 DNS > Secondary DNS
Other Phones:
Network > Basic > IPv6 Config > Static IP Address > Secondary DNS
Phone UI
Color Screen Phones:
Menu > Advanced (default password: admin) > Network > WAN Port > IPv6 > Static IP > Secondary
DNS
In DHCP environment:
Menu > Advanced (default password: admin) > Network > WAN Port > IPv6 > DHCP > Static DNS
(Enabled) > Secondary DNS
Black-and-white Screen Phones:
Menu > Settings > Advanced Settings (default password: admin) > Network > WAN Port > IPv6 >
Static IPv6 Client > Sec.DNS
In DHCP environment:
Menu > Settings > Advanced Settings (default password: admin) > Network > WAN Port > IPv6 >
DHCP IPv6 Client > Static DNS(Enabled) > Sec.DNS
Parameter
static.network.ipv6_icmp_v6.enable
[1]
<y0000000000xx>.cfg
Description
It enables or disables the phone to obtain IPv6 wired network settings via SLAAC (Stateless Address
Autoconfiguration).
Note: It works only if “static.network.ipv6_internet_port.type is set to 0 (DHCP).
Permitted
Values
0-Disabled
1-Enabled
Default
1
Supported
Devices
T57W, T54W, T53W, T53, T48U, T48S, T48G, T46U, T46S, T46G, T43U, T42U, T29G
Web UI
Network > Advanced > ICMPv6 Status > Active

Table of Contents

Other manuals for Yealink SIP-T40G

Related product manuals