EasyManua.ls Logo

Yealink SIP-T40G

Yealink SIP-T40G
572 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Administrator’s Guide for SIP-T2 Series/T4 Series/T5 Series/CP920 IP Phones
445
Related Topic
Macro Action Strings
BLF Key LED/Icon and Behavior for Idle State Configuration
The following table lists the parameters you can use to configure BLF key LED/icon and Behavior for the idle state
(the monitored user is idle).
Parameter
blf.enhanced.idle.enable <y0000000000xx>.cfg
Description
It enables or disables the custom configuration when the monitored user is idle.
Permitted
Values
0-Disabled
1-Enabled, the phone will display the custom BLF/BLF List DSS key LED status/icon colors and per-
form the custom behavior when pressing the BLF/BLF List DSS key.
Default
0
Supported
Devices
All phones except T19(P) E2 and CP920
Parameter
blf.enhanced.idle.led <y0000000000xx>.cfg
Description
It configures the custom BLF/BLF List DSS key LED status/icon colors when the monitored user is idle.
This value uses the same macro action string syntax as an Enhanced DSS key.
Example:
blf.enhanced.idle.led = $LEDg1000o$
For T57W/T48U/T48S/T48G phones, the BLF/BLF List DSS key field displays a green icon for 1000ms
and then turns to white.
For other phones, the BLF/BLF list DSS key LED glows green for 1000ms and then goes out.
Note: It works only if “blf.enhanced.idle.enable is set to 1 (Enabled).
Permitted
Values
String
Default
Blank
Supported
Devices
All phones except T19(P) E2 and CP920
Parameter
blf.enhanced.idle.callin.action <y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is ringing and mon-
itored user is idle.
Note: It works only if “blf.enhanced.idle.enable is set to 1 (Enabled).
Permitted
Values
String
Default
Blank
Supported
Devices
All phones except T19(P) E2 and CP920
Parameter
blf.enhanced.idle.talking.action <y0000000000xx>.cfg
Description
It configures the behavior when pressing the BLF/BLF list DSS key if the monitor is talking and mon-
itored user is idle.
Note: It works only if “blf.enhanced.idle.enable is set to 1 (Enabled).
Permitted
String

Table of Contents

Other manuals for Yealink SIP-T40G

Related product manuals