Yealink T40G Configuring Guide

Yealink IP Phones Configuring Guide
40
 Zero Touch
The following sections introduce common methods to trigger the phone to perform auto
provisioning.

Power On

Auto Provision Now

Zero Touch
Power On
You can power on the phone to trigger it to perform auto provisioning.
To trigger auto provisioning via powered on:
1. After powered on, the phone needs your provisioning credentials to download
configuration files from the CommPortal phone configurator.
If you enter valid provisioning credential, the phone will download configuration files
successfully. If not, the phone enters the idle screen:
2. Press the Login soft key to enter the Auto Provision screen again.
3. Enter your provisioning credentials.
4. Press the OK soft key.
The phone reboots and download configurations from the CommonPortal phone
configurator.
Auto Provision Now
You can use the Auto Provision Now method to trigger the IP phone to perform the auto
provisioning immediately.

Yealink T40G Specifications

General

SIP Accounts	3
Wall Mountable	Yes
Opus Codec	No
Display	2.3 inch 132x64-pixel graphical LCD
Network	Dual-port Gigabit Ethernet
PoE	Yes
Headset Support	Yes, RJ9 port
Power Adapter	Optional
Voice Codecs	G.722, G.711(A/μ), G.729AB, G.726
Local Phonebook	1000 entries