Yealink VC120 - User Interfaces

Overview
21
Indicator LED on the video conferencing phone:
LED Status
Description
Solid red
The phone is initializing.
The call is muted.
Flashing red
The phone is ringing.
Solid green
The phone is placing a call.
There is an active call on the phone.
Off
The phone is idle.
Mute Indicator LED on the VCM30 video conferencing microphone array:
LED Status
Description
Solid red
The VCM30 is muted when the VC120 is during a call.
Flashing red
The VC120 is ringing.
Solid green
The VCM30 is connected to the VC120 Codec within the
first 5 seconds.
The VC120 is placing a call.
The VCM30 is unmuted when the VC120 is during a call.
Off
The VCM30 is not connected to the VC120 Codec.
The VCM30 is idle.
User Interfaces
There are two ways to customize the configurations of your VC120 video conferencing system:
 Web User Interface
 Remote Control
Note
Web User Interface
You can customize your system via web user interface. To access the web user interface, you
need to know the IP address of your new system.
To obtain the IP address, do one of the following:
 The IP address of the system is shown on the top right corner of the display device.
 Press (Menu soft key) on your remote control and select Status ->Network.
The display device shows network information about the system.
The display device and remote control constitute the system user interface. This allows the user
to execute all call operation tasks and basic configuration changes directly. Detailed operational
steps will be explained in the feature section.