NeoGate TG Series User Manual
44/62
over this trunk.
Enable SRTP
Define if SRTP is enabled for this trunk, it depends on
provider’s configuration.
Send check alive packets to the SIP provider.
Enable outbound
A proxy that receives requests from a client, even though
it may not be the server resolved by the Request-URI.
Define the codec for this SIP trunk and its priority
Transport
This will be the transport method used by the SIP Trunk.
This method is given by the SIP trunk provider. The
options are UDP (default) or TCP or TLS.
DTMF Mode
Set default mode for sending DTMF of this trunk. Default
DOD settings
DOD (Direct Outward Dialing) means the caller ID
displayed when dialing out, before configure this, and
please make sure the provider supports this feature.
3) Service provider
This is service provider trunk (peer to peer mode), which uses IP address only.
If you have got a trunk with only IP address, please choose this type.
Figure 7-16
Choose trunk mode to register to provider
Choose the type of this trunk, SIP or IAX
Input the name of provider
Hostname/IP
Service provider’s hostname or IP address,
5060 is the standard port number used by SIP
protocol. Don’t change this part if it is not
required.
To Next Page
Loading...
Need help?
General
