NeoGate TG Series User Manual
58/62
Enable Callback
C
hoose whether call back is enabled, you can
configure the advanced call back settings in part:
7.3.4.
Choose the destination trunk to route the call to
Hotline
When it’
s configred, this number will be dial via
destination trunk permanently
Two stage Dial
Enable it to get the customized two stage dial tone
before dial out, it’s disabled by default.
Outbound Dial Pattern
Outbound calls that match this dial pattern will use
this outbound route. Hover the pointer over to
read tips.
Strip digits from front
before dialing
Allows the user to specify the number of digits that
will be stripped from the front of the phone number
before the call is placed.
before dialing
These digits will be prepended to the phone
number before the call is placed
7.3.3 Blacklist
Blacklist is used to block an incoming/outgoing call. If the number of
incoming/outgoing call is listed in the number blacklist, the caller will hear the
following prompt: “The number you have dialed is not in service. Please check
the number and try again”. The system will then disconnect the call.
Figure 7-34
We can add a number with the type: inbound, outbound or both.
7.3.4 Callback Settings
NeoGate TG allows caller A to dial an inbound route number, and after hearing
the ring, A can hang up the call or wait for NeoGate TG to cut off the call, then
To Next Page
Loading...
Need help?
General
