FXS Gateway TA400/800 User Manual
General
Table 4-1 Description of FXS Port General Settings
General
Port The corresponding port.
Number User account number.
VoIP Serer
Template
Primary Server
Choose the Primary VoIP server, where the
account will be registered.
Failover Server
Choose the failover server for the account. This
server will be used if the primary server is
User Name
Username of the account. Used for VoIP trunk
registration. The user name should be entered if
the "Enable Register" is checked on the VoIP
Authentication
Name
Used for SIP authentication. The authentication
name should be entered if "Enable Register" is
checked on the VoIP Server.
Password
Password of the SIP account. The password
should be entered if "Enable Register" is
checked on the VoIP Server.
From User
All outgoing calls from this SIP Trunk will use the
"From User" (in this case the account name for
SIP Registration) in From Header of the SIP
Invite package. Keep this field blank if not
Online Number
Define the online number that expected
by “Skype Connect” and some other SIP service
providers. Leave this field blank if not needed.
Dial Pattern Template
The account will be allowed to make outbound
calls according to the selected template.
Hotline
Enable Hotline
Select whether to use Hotline or not. Hotline is
disabled by default. If this feature is enabled, the
system will dial out the hotline number
automatically after off-hook.
Hotline Number
Set the number to dial out automatically after
off-hook.
Delay Dial
Define how long to make Hotline take effect after
you pick up the phone.
Flash
Sets the amount of time, in milliseconds, that a
hook flash must remain depressed in order for
the system to consider it as a valid flash event.
Set up the max cull duration for every call of this
31/59
To Next Page
Loading...
Need help?
General
