Yeastar Technology TA810 - FXO Port Call Duration Settings

TA410/810 User Manual
12/63
6 - 370 Ohm + (820 Ohm || 110nF)
7 - 275 Ohm + (78 Ohm || 150 nF)
8 - 120 Ohm + (820 Ohm || 110 nF)
9 - 350 Ohm + (1000 Ohm || 210nF)
10 - 0 Ohm + (900 Ohm || 30nF)
11 - 600 Ohm + 2.16 uF
12 - 900 Ohm + 1 uF
13 - 900 Ohm + 2.16 uF
14 - 600 Ohm + 1 uF
15 - Global complex impedance
2) Call Duration Settings
Figure 3-2 FXO Port Call Duration Setting
Table 3-2 Description of FXO Port Call Duration Settings
Items
Description
Single CallMax Duration(min)
Configure the duration of each call, it’s 0 by default,
which means no limit.
Round up Duration
Once the value of Billing Unit is changed, the
“Round Up Duration” will be cleared, “Call
Duration” will also change accordingly.
Max. Call Duration(min)
Defines the maximum number of billing unit called
within a month through the trunk. To disable this
limitation set the value at 0.
Enable Clear Stat.
The date to clean the duration status each month.
Balance Alarm Settings
When Max. Call Duration(min) is configured a 0 (no