Specification of Parameters in a Command
To use parameters in a command, a space must be placed between the command and
parameters. Each parameter is delimited by a comma “,”. A space may also be placed
before and after a comma to make the command legible.
AQ6317-Compatible Commands
The instrument supports AQ6317-compatible GP-IB commands. When using AQ6317-
compatible GP-IB commands, call up the SYSTEM menu using the SYSTEM key and
place the instrument in AQ6317-compatible mode.
Differences from the AQ6370
This instrument’s remote commands differ from those of the AQ6370 in the following
respects.
1. *IDN query talker data
AQ6370: "YOKOGAWA, AQ6370,----"
AQ6370C: "YOKOGAWA, AQ6370C,----"
AQ6370D: "YOKOGAWA, AQ6370D,----"
AQ6373: "YOKOGAWA, AQ6373,----"
AQ6373B: “YOKOGAWA, AQ6373B,----”
AQ6375: "YOKOGAWA, AQ6375,----"
AQ6375B: “YOKOGAWA, AQ6375B,----”
2. “CHOP” was eliminated from the <CHOP MODE> settings.
If the AQ6370C/AQ6370D/AQ6373/AQ6373B receives a command that specifies
“CHOP,” it is treated as “SWITCH.”
7.1 Rules of Syntax and Command Types
To Next Page
Loading...
