YOKOGAWA BT200

4-14
<Toc> <Ind> <4. BT200 BASIC OPERATIONS >
IM 01C00A11-01E
(4) ENTER A SECURITY CODE (IF ONE HAS
BEEN SET)
To alter setup data for the first time after switching on
the BT200, select the security code setup panel. You
must type the correct security code, in order to rewrite
parameters for the connected instrument.
You must to type the security code only once after the
BT200 is switched on. Reentry is not needed until you
switch off the BT200.
F0419.EPS

PARAM
C10:TAG NO.
TABC-101
C20:PRESS UNIT
mmH2O
C21:LRV
 0 mmH2O
DATA DIAG PRNT ESC
SECURITY
ID:BT200 
SECURITY CODE
:***_
CLR ESC
SET
C10:TAG NO.
TABC-101
TABC-101
CODE CAPS CLR ESC
1.Select ‘C10: TAG No.’ and
press [ENT] to change the tag
number. 
 ‘SECURITY CODE SETUP
Panel’ is displayed only if the
tag number is changed for the
first time.
PARAMETER PANEL
SECURITY CODE
SETUP PANEL
SETUP PANEL
* * * *
2.Type the security code (four
digits) and press [ENT].
✻If you type the wrong security
code and press [ENT], the
message “incorrect CODE” is
displayed. Type the correct
security code.