1-7
IM 701610-61E
1
I
2
C-Bus Signal Analysis Function
• When I2C → Pattern Is Selected
33. Press the Set Pattern soft key. The Set Pattern dialog box appears.
Setting the CH3 and CH4 Pattern
34. Turn the jog shuttle to move the cursor to Pattern CH3 or CH4.
35. Press SELECT to select H, L, or X.
Setting the Trigger Condition
36. Turn the jog shuttle to move the cursor to Condition.
37. Press SELECT to select Enter or Exit.
Press ESC to close the dialog box.
Note
If you selected “I2C → Pattern” for Combination and set the patterns of CH3 and CH4 to “X,”
triggers will not be activated.
1.3 Setting the Trigger Conditions
To Next Page
Loading...
