2. Power-on and Power-off
The power of the flash light can be opened or closed by holding this button for 2 seconds. It is suggested that
the battery shall be taken out after the power of the flash light is closed through this button.
After opening the power switch of the flash, the flash will fetch the setting state saved in the closedown last
time, the charging indicator is red, which indicates the flash is available.
If
the
cha
rging
is
not
completed
wi
thin
20
seconds,
the power is low, and <P.L> will be displayed on LCD panel,
the speedlite will automatically shutdown. The you need to replace with new batteries.
You may press the testing button PILOT to test whether the flash works normally.
After use, hold the power switch for 2S to power off.
3. ETTL MODE
Just set the camera’s shooting mode to [AV] (aperture-priority AE), [TV] (shutter-priority-AE), or [M](manual),
and you can use ETTL autoflash. Under the ETTL mode, YN565EX supports FEC, FEB, Rear-sync, FEV,
Modeling, Canon camera menu accessable.
4. M mode
You can set the flash output from 1/128 to 1/1 full power in 1/3-stop
increments. Press the [LEFT] [RIGHT] button to adjust the output directly.
Press [MODE] button and the <M> will display on LCD panel.
Press [LEFT] and [RIGHT] button to adjust output level, you
the step size is 1/3ev.
Press the shutter button halfway, and check that the
subject is within the effective range displayed on
the LCD panel.
can fine tune the power output of the flash by [UP] and [DOWN],
-43-
To Next Page
Loading...
Need help?
General
