(2). Wireless flash with three YN565EX speedlites
Wireless option setting: cn, c, n
Channel setting: 1, 2, 3, 4
Groups setting: Set three YN565EX speedlites as group A, group B and
group C respectively.
Setting master and shooting: Please select the ratio<A: B C>.
Press the test button of master to test whether the flash works normally;
if the flash does not fire, adjust the
slave unit’s angle toward the master
unit and distance from the master unit.
3. Multi-Speedlite, Wireless lighting configurations
You can create two or three slave groups to make shooting effect better meet your requirements, and set flash
ratio for ETTL autoflash shooting of master, as well as manual flash output, frequency flash etc.
Prompt: When does it need to set c or n under the off camera mode instead of cn mode?
When other cameraman uses off camera control in the environment, and you don’t want to be bothered. Separate
setting of c or n may slightly improve the correctness of flash control.
(1). Wireless flash of two slave units made up by YN565EX.
� Wireless option setting: cn, c, n for operation
� Communication Channel setting: 1, 2, 3, 4
� Groups setting: Set one YN565EX as group A, and set the
other one as group B.
� Master unit setting: Set the communication channel, Set the
flash ratio of master unit A:B or A:B C. You can conduct
flash shooting.
��
-50-
To Next Page
Loading...
Need help?
General
