4. Exposure Bracketing (FEB)
The FEB function is set on the camera or speedlite. For the specific setting method, refer to your Camera
Instructions. After the FEB is set, after 3 photos are taken, exposure compensation will be made automatically
in the sequence of, for example, “normal
under over”. This function helps you improve the success rate
of photo taking.
The setting method on the YN565EX speedlite: Press the [UP] [DOWN] button to adjust the exposure
bracketing amount.
NOTE: For FEB, set the camera’s drive mode to single shooting. Be sure the flash is ready before shooting.
6. FV Lock (Nikon)
-54-
5. FE Lock (Canon)
To use this function, cover the subject for which flash exposure will be locked at the center of the viewfinder of
camera, press the button <*> of the flash exposure lock, and the flash light will pre-flash and the camera will
calculate the appropriate flash output data. Now you have some time for decomposition, after which, you can
take photo. (The function can be used only when it is supported by your camera. For the setting method, refer
to your Camera Instructions.)
Set the AE-L/AF-L function as FV Lock on the camera before using this function. At this time, you can aim at your
desired object in the viewfinder and then press the AE-L key or AF-L key, in such case, the flash light will pre-flash
to get the reading of flash exposure for the object; after you have confirmed the scene frame, press the shutter.
(This function can only be available when your camera supports it; for the setting of AE-L and AF-L, refer to your
camera manual).
To Next Page
Loading...
Need help?
General
