Zebra 105SL Plus User Manual

Troubleshooting
Printer Diagnostics
150
P1056468-002 7/3/13
PAUSE Self Test
This self test can be used to provide the test labels required when making adjustments to the
printer’s mechanical assemblies or to determine if any printhead elements are not working.
Figure 15 shows a sample printout.
To perform a PAUSE self test, complete these steps:
1. Turn off (O) the printer.
2. Press and hold PAUSE while turning on (I) the printer. Hold PAUSE until the first control
panel light turns off.
• The initial self test prints 15 labels at the printer’s slowest speed, and then
automatically pauses the printer. Each time PAUSE is pressed, an additional 15 labels
print. Figure 15 shows a sample of the labels.
Figure 15 • PAUSE Test Label
• While the printer is paused, pressing CANCEL alters the self test. Each time PAUSE
is pressed, 15 labels print at 6 in. (152 mm) per second.
• While the printer is paused, pressing CANCEL again alters the self test a second
time. Each time PAUSE is pressed, 50 labels print at the printer’s slowest speed
• While the printer is paused, pressing CANCEL again alters the self test a third time.
Each time PAUSE is pressed, 50 labels print at 6 in. (152 mm) per second.
• While the printer is paused, pressing CANCEL again alters the self test a fourth time.
Each time PAUSE is pressed, 15 labels print at the printer’s maximum speed.
3. To exit this self test at any time, press and hold CANCEL.

Zebra 105SL Plus Specifications

General

Weight	50 lbs / 22.7 kg
Humidity	20-85% non-condensing
Print Method	Thermal Transfer
Resolution	203 dpi (8 dots/mm)
Max Print Width	4.09 inches / 104 mm
Max Print Speed	12 inches per second / 305 mm per second
Memory	16 MB SDRAM, 8 MB Flash
Media Width	0.79 inches / 20 mm to 4.5 inches / 114 mm
Media Thickness	0.003 inches / 0.076 mm to 0.012 inches / 0.305 mm
Media Types	Continuous, die-cut, black mark
Ribbon Width	2.00 inches / 51 mm to 4.33 inches / 110 mm
Ribbon Length	1476'/450 m
Connectivity	Parallel, Serial
Optional Connectivity	Ethernet, Wireless
Power Requirements	90-264 VAC; 48-62 Hz
Operating Temperature	40°F to 105°F / 5°C to 40°C
Storage Temperature	-40°F to 140°F / -40°C to 60°C