CHAPTER 7 USER PREFERENCES &
MISCELLANEOUS SCANNER
OPTIONS
Introduction
If desired, configure the linear imager to perform various functions, or activate different features. This chapter
describes imaging preference features and provides programming bar codes for selecting these features.
The linear imager ships with the settings in User Preferences Parameter Defaults on page 7-2 (also see
Appendix A, STANDARD DEFAULT PARAMETERS for all host device and miscellaneous defaults). If the default
values suit requirements, programming is not necessary.
To set feature values, scan a single bar code or a short bar code sequence. The settings are stored in
non-volatile memory and are preserved even when you power down the linear imager.
If not using a USB cable, select a host type (see each host chapter for specific host information) after the
power-up beeps sound. This is only necessary upon the first power-up when connecting to a new host.
To return all features to default values, scan the Default Parameters on page 7-4. Throughout the programming
bar code menus, asterisks (
*) indicate default values.
NOTE Most computer monitors allow scanning the bar codes directly on the screen. When scanning from the
screen, be sure to set the document magnification to a level where you can see the bar code clearly, and
bars and/or spaces are not merging.
Feature/Option
*Indicates Default
*Do Not Suppress Power Up Beeps
To Next Page
Loading...
Need help?
General
Weight and Dimensions
