USER PREFERENCES & MISCELLANEOUS SCANNER OPTIONS 7 - 9
Suppress Power Up Beeps
Parameter # 721
Scan a bar code below to select whether or not to suppress linear imager beeps upon power up.
Hand-Held Trigger Mode
Parameter # 138
Select one of the following trigger modes for the linear imager:
•
Standard (Level) - A trigger pull activates decode processing. Decode processing continues until the bar
code decodes, you release the trigger, or the Decode Session Timeout occurs.
•
Presentation (Blink) - The scanner activates decode processing when it detects a bar code in its field of
view. After a period of non-use, the scanner enters a low power mode, in which the LEDs turn off until the
scanner senses motion.
•
Auto Aim - This trigger mode projects the red illumination when you lift the linear imager. A trigger pull
activates decode processing. After 2 seconds of inactivity the aiming pattern shuts off. (See Aiming
Illumination on page 7-12 to set the type of pattern when aiming.)
*Do Not Suppress Power Up Beeps
(00h)
Suppress Power Up Beeps
(01h)
*Standard (Level)
(00h)
Presentation (Blink)
(07h)
Auto Aim
(09h)
To Next Page
Loading...
