SAFETY INSTRUCTIONS
ZEISS General Information Axio Observer
8 431004-7244-001 12/2016
2 SAFETY INSTRUCTIONS
2.1 General Information
Regulations for occupational health and safety must be observed when operating the
HXP 120 V source of UV radiation. The national legal requirements must also be observed.
− Follow the operating manual for the HXP 120 V illuminator as supplied by the manufacturer.
− The lamp must be replaced according to the manufacturer’s instructions. There is otherwise
a risk of burning or explosion when the lamp is replaced.
− The user should not expose him/herself to UV radiation from the HXP 120 V illuminator.
− Never look directly into the optical fiber when the HXP 120
V illuminator is switched on.
Failure to observe this precaution may result in irreversible eye injuries!
Avoid touching the hot lamp housing. Always pull out the power plug before changing the
lamps and allow the instrument to cool down for approx. 15 minutes.
Observe the operation manuals for the illumination systems Colibri.2 and Colibri 7 (423052-
7244-001 and 423052-7344-001).
The Axio Observer may not be put into operation if the dust cover is still on. Before putting on
the dust cover, always check that the device is switched off and has cooled down, otherwise
this could cause a fire.
Immersol 518 F
immersion oil is a skin irritant. Avoid contact with skin, eyes and clothing.
In the event of contact with the skin, rinse with plenty of water and soap. In the event of
contact with the eyes, rinse the eye immediately with plenty of water for at least five minutes. If
irritation persists, consult a physician.
Proper disposal of Immersol 518 F
®
immersion oil: Ensure that immersion oil does not enter
surface water or the sewage system.
Users must read the safety data sheet for Immersol 518 N
Fluorescence illuminators such as the HBO 100 or Colibri.2 emit ultraviolet radiation which may
cause burns to eyes and skin. Never look directly into the light and avoid direct skin exposure.
When using the micro
scope, always use the device's protective equipment (e.g. special
attenuation filters).
Gas discharge lamps such as HBO 100 develop high internal pressure when hot. They should
therefore only be replaced when cool. Protective gloves and eyewear should
detailed information, please see operating manual 423010-7144-001).
To Next Page
Loading...
