EasyManua.ls Logo

Zenith SENTRY 2 - Typical Control Panel; Sleep Timer (some Models)

Zenith SENTRY 2
31 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
GETTING TO KNOW YOUR TV
TYPICAL CONTROL PANEL
The control panel on your TV may differ from the one
shown.
NOTE: Some TVs have a vertical control panel - the
operation is the same as described for the control panels
shown above.
ENTER (ENT) SELECT (SEL) VOLUME (VOL) Up/Down OFF-ON
Press to see the Channe!/Time dis- Press during on-screen menu Press to increase or decrease Press to turn TV
play, or to remove any on-screen operations to select a menu op- the sound level, power ON or OFF.
display or menu. tion.
ADJUST (ADJ) Left/Right
Press during on-screen menu
operation to see information/status
display for selected option. Press
again to adjust the selected menu
option.
MENU
Press once to see amenu. Press
repeatedly to sequence through
the available menus.
CHANNEL (CH) Up/Down
Press to select channels higher
or lower than the channels being
viewed. You can add channels to
or delete channels from the scan-
ning sequence stored in memory
of the TV. See CH. ADD/DEL
option for channel programming
information.
Remote Window
Point the remote
control towards
this window to
operate the TV.
SLEEP TIMER (SOME MODELS)
Some remote controls are equipped with a TIMER button
that provides access to the SLEEP TIMER available with
some TV models. By using the SLEEP TIMER, you can
program the TV to automatically shut off after a period
from 15 minutes up to 4 hours.
To Set SLEEP TIMER
1. Press TIMER to see status display.
2. Press TIMER repeatedly until you reach desired
shut-off time.
One minute before the TV shuts off, the GOOD NIGHT
display appears on the screen. At this time you have a
choice of the following three actions.
1. Do nothing. The TV will shut off in one minute.
2. Remove the GOOD NIGHT display by pressing
ENTER (ENT). The TV will still shut off in one minute.
3. Delay the shut off by using TIMER to select a new
shut off time.
To Cancel the SLEEP TIMER
You can cancel the SLEEP TIMER by setting the SLEEP
TIMER status to OFF. Press TIMER repeatedly until OFF
is selected.
NOTE: The SLEEP TIMER resets to OFF when you turn
off the TV.
SLEEP TIMER
0:15
PRESS TIMER
KEY TO CHANGE
Sleep Timer Display
GOOD NIGHT
J
"Good Night" Display
2731-O 3 -- 1
All manuals and user guides at all-guides.com

Other manuals for Zenith SENTRY 2

Related product manuals