System Configuration
6. The following system parameters require configuration:
• IP Address
• Netmask
• IP Gateway
The remainder of the system parameters can be left at their defaults or adjusted according
to your preferences. The following table describes the purpose of each system parameter.
Table 6 - IP Gateway system parameters
Parameter Purpose
Gateway Name/ID The informal name of the IP Gateway.
Default is the unit’s MAC address. 1-20 characters long.
Configuration Name The informal name of the current configuration, used to identify different
configurations or as installer notes.
Default “IPG-Config”. 1-20 characters long.
IP Address The unique IP address of this IP Gateway. The address is typically assigned by
your network administrator and it must be unique.
The default setting is determined by the position of IP Gateway DIP switch B.
(See DIP Switches on page 18.) (Default) UP = 192.168.0.1 and DOWN =
1
92.168.0.133
Netmask Indicates class of network. Typically 255.255.255.0. Check with your network
administrator.
Default 255.255.255.0.
IP Gateway The IP address of the network’s Internet gateway. Typically assigned by your
network administrator.
Default 192.168.0.100.
DNS Server 1 IP Address If there is a domain name server and you would like the IP Gateway to use it,
enter its IP address here.
Password The password used to access the web configuration.
Default “8206363”.
Allow FTP Turns FTP access on or off. FTP is used to update the IP Gateway’s firmware.
Default checked.
7. Click Submit. The main web page for the IP Gateway should redisplay.
8. Submitting the changes does not alter the configuration of the IP Gateway. Click
Save Changes to update the IP Gateway settings with the new configuration.
9. Wait for the unit to automatically reboot.
26 025-9631D.1
To Next Page
Loading...