16
Quick Start Guide
Starting the Show
Set the Playback X MASTER and GRAND MASTER faders to full. Ensure that Blackout is not active. Check that the
OVERRIDE control is in it’s central position.
Select the rst programmed memory using the arrow keys and press the GO button. The memory fades up according
to it’s programmed fade and delay times.
Selecting the Next Memory
After a cue is run, the next memory will automatically move on to the next programmed memory. To select a different
memory to be output next – move the cursor to the Next memory number eld, then use the + and – keys or the UP
and DOWN arrow keys to select the next memory to be output. The Next memory to be output is highlighted by a yellow
bar.
Using the GO Button
When a memory is triggered by the GO button, the Intensity, Colour, Beamshape and Position fades will occur in the
times programmed. If necessary, all fades may be controlled by the OVERRIDE and PAUSE controls on the front panel.
Figure 15 - Playing back Memories
To Next Page
Loading...
Need help?
General
