Saving Shows
24
Saving Shows
The Solution & Solution XL saves the show automatically to its internal memory at regular intervals. External backups
of the show data can be made to a USB Storage Device (eg memory stick).
Connect your storage device to one of the USB ports on the desk. If using an external oppy drive, remember to insert
a oppy disk into the drive.
Press the [Files] MFK or select the [Files] button on the Setup Window.
Press the [Save Show ] MFK or select the [Save Show] button on the monitor. The Save Show window is displayed
on the monitor. Select the required Destination Device, by pressing the relevant MFK. If you do not see your device
immediately, press Refresh.
Now you can enter a name for the show le, using the MFKs like a mobile phone text message. You can also use
the on-screen keyboard at this point, or a USB keyboard, if required. This name will be used as the le name on the
destination device, so ensure it is unique and easily identiable. Once you have entered the name, press ENTER, then
press the [OK] MFK to save the show.
Figure 22 - Saving a Show
Loading Shows
Note: Loading a show file will clear any existing show data from the desk so ensure that you have backed up
your previous show before you load another one onto the desk.
To load a show, connect the storage media to a USB port on the desk. If you’re using an external oppy drive, remember
to insert the oppy disk into the drive.
Press the [Files] MFK, then press the [Load Show] MFK The Load Show window is displayed on the monitor. Select the
required source device, using the MFKs.
A list of show les found on the selected device is displayed in the window (this may require you to use the Page Function
to locate your show, if a lot of les are found on the disk). Select the required show le from the list, then press the [OK]
button to load the show.
To Next Page
Loading...
Need help?
General
