18
Submasters
Playing Back Submasters
Before playing back submasters, it is important to clear the Program Window by pressing the CLEAR button.
This prevents any unprogrammed data from affecting the outuput of the submasters.
Raising a submaster fader will bring the data programmed on the submaster to the outputs. For moving lights, the
submaster will trigger at 5% a crossfade to the new values. For generic lights, the submaster fader provides intensity
control.
Figure 17 - Playing Back Submasters
Page Overlay on Submasters
It is possible to output scene or chase data from several submasters on different pages at the same time provided that
they are not controlled by the same physical fader.
If the submaster page is changed while any of the submaster faders are up, or any of the SUBMASTER FLASH buttons
are being held down, the fader or button remains in control of the original data and the outputs for the original submaster
are held.
The new scene, chase or transferred memory associated with the fader or button is not made available until the fader
is brought back down to zero or the ash button is released.
To Next Page
Loading...
Need help?
General
