Preset Faders
The Solution desk has 48 preset faders arranged as two rows of 24 faders and buttons. These control 24 dimmer channels
in two preset mode or 48 dimmer channels in Wide mode.
The Solution XL desk has 96 preset faders arranged as two rows of 48 faders and buttons. These control 48 dimmer
channels in two preset mode or 96 dimmer channels in Wide mode.
Figure 2 - Preset Controls
Channel Flash Buttons
The Solution desk has 48 ash buttons located below the PRESET faders.
The Solution XL desk has 96 ash buttons located below the PRESET faders.
The CHANNEL FLASH buttons are used to ash, solo or latch the dimmer channels or to select the channels or xtures
assigned to the corresponding faders; their action being determined by the setting of the FLASH MODE button in Special
Page 1 of the MFKs.
A and B Master Faders
Two Preset Operation – The A MASTER fader controls the maximum output levels from the PRESET A FADERS.
The B MASTER fader controls the maximum output levels from the PRESET B FADERS.
Wide Operation – The A MASTER and B MASTER faders control the maximum output levels from all the PRESET faders
or the stored scene according to the setting on the PRESET CONTROL button.
Preset Control Button
The PRESET CONTROL button is only applicable in Wide Mode and is used to control which of the A or B MASTER faders
has control of the preset faders and which has control over the stored scene. The red LEDs in the button indicate the
current state. Pressing the button swaps the function of the two faders.
5
Preset Controls
To Next Page
Loading...
Need help?
General
