6 Installation and Operating Instructions V03
2 Safety
2.1 Intended use
1. Zeverlution converts the direct current from PV array into grid-compliant
alternating current.
2. Zeverlution is suitable for indoor and outdoor use.
3. Zeverlution must only be operated with PV arrays (PV modules and cabling) of
protection class II, in accordance with IEC 61730, application class A. Do not
connect any sources of energy other than PV modules to the inverter.
4. PV modules with a high capacitance to ground must only be used if their coupling
capacitance does not exceed 1.0μ F.
5. When the PV modules are exposed to sunlight, a DC voltage is supplied to this
equipment.
6. When designing the PV system, ensure that the values comply with the permitted
operating range of all components at all times. The free design program
‛Zeverplan“ (http://www.zeverplan.com ) will assist you.
2.2 Safety standards
Zeverlution inverters comply with the EU Low-Voltage Directive 2006/95/EC and the
EMC Directive 2004/108/EC. Zeverlution also complies with the requirement for
safety and EMC in Australia and New Zealand market. They are labeled with the CE
mark and RCM mark.
For more information about certificates in other countries and regions, please visit
website ( http:// www.zeversolar.com ).
To Next Page
Loading...
