ZiLOG System 8000 Hardware Reference Manual

HRt4 Zilog
***** RESET TEST LINE (OPTIONAL) *****
the test line is currently set as follows:
HRM
NAME
MMUTST5
flREPS
PARAMETERS 1-4
No parameters to set
o
/I
~
R to reset REPETITION count
I test name is INCORRECT - choose different test
<CR> if test line is correct
~ to return to COMMAND LEVEL
Enter your choice J=>
The
MMUTST5 test line is displayed with default parame-
t er sse t by SA DIE. Th e de fa u1 t rep e tit ion co un t, 1, 0 r
the parameters can be modified. To reset the repetition
count, enter R in response to the prompt "Enter your
choice] =>", followed by <CR>. The following display
appears:
***** SET REPETITION COUNT *****
Current repetition count =
to run test until NMI pressed
(positive # <=9999) to run test this many times
to return to RESET TEST LINE
<CR> to leave repetition count the same
Enter your choice ]=>
To modify the default or existing repetition count, fol-
lowing the prompt "Enter your choice ]=>", enter the
number of times the test is to run. In this case, the
default repetition count, 1, is changed to 5. When <CR>
is entered, the following display appears:
5-66
Zilog
5-66

ZiLOG System 8000 Specifications

General

Brand	ZiLOG
Model	System 8000
Category	Desktop
Language	English