ZiLOG System 8000 Hardware Reference Manual

HRM 2ilog
***** RESET TEST LINE (OPTIONAL) *****
The test line is currently set as follows:
HRM
NAME
MMUTST5
ffREPS
-5--
PARAMETERS 1-4
No parameters-to set
R to reset REPETITION count
I test name is INCORRECT - choose different test
<CR> if test line is correct
A to return to COMMAND LEVEL
Enter your choice J=>
When satisfied with the repetition count, enter <CR> in
respons'e to the pr'ompt 1fEnter your choice J=>". This
changes the test into a special one-line test list. The
list check and verification of any attempt to overwrite
the tape is then performed just as in running a regular
test list. During the list check and verification pro-
cess, the following message is displayed:
***** CHECKING TEST LIST ... *****
LINE 1: OK
***** CHECK COMPLETE *****
After the CHECK COMPLETE message, the following display
appears:
*******************************************************
The following test is now running
NAME ffREPS PARAMETERS 1-4
MMUTST5 5 No parameters to set
*******************************************************
This is MMUTST5 - version 1.01
Now doing a block random data test on all MMUs.
Now testing SDRs with random data and random accesses.
Now testing control registers with random data.
Now testing READ ONLY flags in the data and stack MMUs.
Now testing the LIMIT flags of the stack and data MMUs.
Now testing the DIRW (direction) flag of the stack and
data MMUs.
Now testing TRANSLATION on the DATA MMU seg(1-63).
Now testing TRANSLATION on the STACK MMU seg(1-63).
Now testing TRANSLATION on the CODE MMU seg(1-63).
5-67
2ilog
5-67

ZiLOG System 8000 Specifications

General

Brand	ZiLOG
Model	System 8000
Category	Desktop
Language	English