38 MicroPro
© gbo Medizintechnik AG Version 1.4
10 Troubleshooting
Problems are indicated by the device acoustically and optically on the display. Most of the
problems can be solved by following the instructions on the display.
In general:
- The malfunction is shown on the display.
- An acoustic error signal is heard.
- Follow the instructions on the display.
Additional suggestions:
• Turn off the unit and turn it on again.
• If the error occurs again, the device is not functioning. Please contact a service au-
thorized by the manufacturer.
Further errors:
The device cannot be
switched on. No display
shown.
Power supply interrupted.
Mains cable, mains plugs or
sockets defect or not
properly connected.
1. Check that the mains ca-
ble, mains plugs and
sockets carry voltage.
2. Check the mains cable,
mains plugs and sockets
for integrity and whether
the plugs are properly
connected to the sockets.
No acoustic signal is heard
(e.g. end of therapy).
Volume of the acoustic sig-
nal to low.
Check the audio settings in
the “Settings” submenu of
the menu bar. The volume
must be greater than 0.
Texts in the display are not
readable. Unknown font.
Check the language set-
tings. Press the flag in the
top right corner and select
your preferred language.
Please contact your service agent or the manufacturer if the problems cannot be solved by
the measures mentioned above.
To Next Page
Loading...
